I am using DirectShow and a Hauppauge video capture card to preview video on a E3825 unit. It is running Win7 32 bit with display driver version 36.15.0.1091 (Driver date 6/26/2014).
My problem is when I use DirectShow and build a filter graph if I use any of the Renderers that directly use the YUY2 data from the capture board then the video on the screen is wrong (see picture below)
and sometimes I get an error message 
so this seems to be a error with the display driver.
Working video and graph ..... but takes 20% of CPU to run this because of the AVI Decompressor.
I also tried this on the same hardware running Win8.1 64 bit and the Video was still wrong but did not get the error message. I also tried this on a module using the N2930 and had the same problem.
Next I tried the same capture board in two other PCs and it worked fine. One PC had a intel CPU but a ATI graphics card the other had a AMD processor with build in graphics.
So my questions :
1. Is there a newer driver I should try?
2. Any other tests I should run?
3. Does anyone else have this problem?
4. I have asked my module company and have tried updating to the latest BIOS and firmware but still the same issue. So I have raised the issue with their support but is there anyone else at Intel I should ask?
Tom