Hi,
I'm fairly new to the Arduino / Edison stuff, so this might be a simple issue but can't seem to figure it out. After uploading the blink application to the break out board, it runs just fine. If I toggle power to the board, most of the time the blink application does not start, I need to upload it again from the Arduino IDE. Sometimes, but only sometimes the application seems to stay resident after reboot (as it should). In that case I can disconnect the board from power as often as I like, the blink app keeps starting up. However most of the time it doesn't startup after reboot after uploading from Arduino. If I look at the sketch.elf file with Putty, it's filesize is 0 bytes in that case.
I'm not able to reproduce this issue, if I upload the sketch (blink app runs), power toggle and wait for the app to start, it will start maybe 1 in 10 or 15 times.
I've updated to the latest firmware (Edison). Also I used the latest version of the Arduino IDE.
Help is greatly appreciated!
Thanks a lot in advance.
Best regards,
Roy