Am trying to boot up the Gordon Peak board(product code:GPMRBBBCHSS3) in ELK(Emergency Linux Kernel) mode but it is not booting.
Below logs are showing whenever target is switched ON
abl-APL: rel.1636
CPU: BXTP-B1 [4C @ 1900MHz: premium SKU], ucode rev.1A; power-on reset
IPC config: R.<16 bytes> (10ms)
PCB #B08F: GR MRB (BMP fab.D, 4x16Gb); BM:0
MRC: [v0.56.16/89.7] FB OK: 8GB
CSE: send DID UMA @10000000, 33MB
CSE: FW 3.0.0.1124
CSE: boot dev #2: SPI
PTT: Waiting for TPM to clear tpmidle ... Done.
auto-boot ...
image#0 - mmcbootX: eMMC boot: No image [err=2:ACK]
image#0 - mmc2:/iasImage: MMC: 0G, boot 0/0 [5.1 HS400 FW 3.5 4e 5/15]:
*** load err #-4
image#1 - mmc1:/iasImage: *** load err #-4
image#2 - ELK: copy ELK from SPI in 3701 ms
image #3: enter CLI ...
>>>
It is copying ELK from SPI but it is not entering into ELK mode.
Is there any way to boot into ELK mode?